Nissan Murano: Transmission & Driveline / Transaxle & Transmission :: Cvt: Re0f10j

Nissan Murano (Z52) 2015-2024 Service Manual / Transmission & Driveline / Transaxle & Transmission :: Cvt: Re0f10j

Transmission & Driveline

..

Precaution. Precautions

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P0603 Ecm


DTC Description DTC DETECTION LOGIC ECM back up system does not function properly. EEPROM (built-in microcomputer) system internal ECM does not function properly. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0603 ECM BACK UP/CIRCUIT [Internal Control Module Keep Alive Memory (KAM) Error] Diagnosis condition Ignition switch ON Signal (terminal) — Threshold ECM back up system does not function properly Diagnosis delay time — P062F CONTROL MODULE (Internal control module EEPROM error) Diagnosis condition Start engine and let it idle Signal (terminal) — Threshold EEPROM (built-in microcomputer) system internal ECM does not function properly Diagnosis delay time — POSSIBLE CAUSEDTC P0603 Harness or connectors [ECM power supply circuit is open or shorted...

Nissan Murano (Z52) 2015-2024 Service Manual: Power Supply and Ground Circuit. Ipdm E/r (intelligent Power Distribution Module Engine Room)


Diagnosis Procedure CHECK FUSIBLE LINKS Check that the following fusible links are not blown: Terminal Signal name Fusible link No. Capacity 1 Battery power supply E 80 A 2 A 250 A C 80 A 3 A 250 A B 100 A N 40 A Is the fusible link blown? YES>> Replace the blown fusible link after repairing the affected circuit...

Categories

LATCH (Lower Anchors and Tethers for CHildren) system

Nissan Murano. LATCH (Lower Anchors and Tethers for CHildren) system

LATCH system lower anchor locations - bench seat

Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.

read more

 
Copyright © 2026 www.nimurano.com