Nissan Murano: Transaxle & Transmission :: Cvt: Re0f10j / Service Data and Specifications (sds). Service Data and Specifications (sds)

Nissan Murano (Z52) 2015-2024 Service Manual / Transmission & Driveline / Transaxle & Transmission :: Cvt: Re0f10j / Service Data and Specifications (sds). Service Data and Specifications (sds)

General Specification

Engine model VQ35DE
Drive type FWD AWD
Transaxle model RE0F10J
Transaxle gear ratio D position 2.413 – 0.383
R position 2.312
Final drive 4.668
Recommended fluid Refer to Fluids and Lubricants
Fluid capacity liter
Shift Characteristics

Unit: rpm

Throttle position Shift pattern CVT input speed
At 40 km/h (25 MPH) At 60 km/h (37 MPH)
2/8 “D” position (Normal) 1,300 – 3,300 1,400 – 4,400
8/8 “D” position (Normal) 2,600 – 3,900 3,400 – 5,000

NOTE:

Lock-up is engaged at the vehicle speed of approximately 10 km/h (6 MPH) to 60 km/h (37 MPH).

Stall Speed

Unit: rpm

Stall speed 2,600 – 2,960
Torque Converter

Unit: mm (in)

Distance “A” between the converter housing and torque converter 14.0 (0.55)
Heater Thermostat
Valve lift More than 5.0 mm (0.197 in)
Valve opening temperature Approx. 71°C (160°F)
Minimum valve lift 5.0 mm/Approx. 85°C (0.197 in/Approx. 203°F)

    Torque Converter and Converter Housing Oil Seal

    Exploded View Transaxle assembly Converter housing oil seal Torque converter : Always replace after every disassembly. : Apply CVT Fluid Disassembly Remove transaxle assembly...

    Driveline :: Transfer: Ty21c

    ..

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: P0794 Intermediate Speed Sensor a


    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0794 INTERMEDIATE SPEED SENSOR A (Intermediate Shaft Speed Sensor "A" Circuit Intermittent) Diagnosis condition TCM power supply voltage: More than 11 V Signal — Threshold Primary pulley speed: more than 11820 rpm Diagnosis delay time Maintained 2 seconds POSSIBLE CAUSE Harness or connector (Primary speed sensor circuit is open or shorted) Primary speed sensor TCM FAIL-SAFE Start is slow Acceleration is slow Lock-up is not performed Manual mode is not activated Confirmation Procedure DTC CONFIRMATION PROCEDURECAUTION: Always drive vehicle at a safe speed...

    Nissan Murano (Z52) 2015-2024 Service Manual: Front Blower Motor


    Diagnosis Procedure CHECK FUSE Ignition switch OFF. Check 15A fuses [Nos. 17 and 27, located in fuse block (J/B)]. NOTE: Refer to Terminal Arrangement Is the inspection result normal? YES>> GO TO 2. NO>> Replace the blown fuse after repairing the affected circuit...

    Categories

    Luggage hooks

    Nissan Murano. Luggage hooks

    When securing items using luggage hooks located on the back of the seat or side finisher do not apply a load over more than 6.5 lbs. (29 N) to a single hook.

    The luggage hooks that are located on the floor should have loads less than 110 lbs. (490 N) to a single hook.

    read more

     
    Copyright © 2026 www.nimurano.com