Nissan Murano: Instruments and controls / HomeLink® Universal Transceiver (if so equipped)

Nissan Murano (Z52) 2015-2024 Owners Manual / Instruments and controls / HomeLink® Universal Transceiver (if so equipped)

The HomeLink® Universal Transceiver provides a convenient way to consolidate the functions of up to three individual handheld transmitters into one built-in device.

HomeLink® Universal Transceiver:

Will operate most radio frequency devices such as garage doors, gates, home and office lighting, entry door locks and security systems.
Is powered by your vehicle’s battery. No separate batteries are required. If the vehicle’s battery is discharged or is disconnected, HomeLink® will retain all programming.

When the HomeLink® Universal Transceiver is programmed,retain the original transmitter for future programmingprocedures (Example: new vehicle purchases). Upon sale of the vehicle, the programmed HomeLink® Universal Transceiver buttons should be erased for security purposes. For additional information, refer to “Programming HomeLink®” in this section.

WARNING

Do not use the HomeLink® Universal Transceiver with any garage door opener that lacks safety stop and reverse features as required by federal safety standards. (These standards became effective for opener models manufactured after April 1, 1982). A garage door opener which cannot detect an object in the path of a closing garage door and then automatically stop and reverse, does not meet current federal safety standards. Using a garage door opener without these features increases the risk of serious injury or death.
During the programming procedure your garage door or security gate will open and close (if the transmitter is within range). Make sure that people or objects are clear of the garagedoor, gate, etc. that you are programming.
Your vehicle’s engine should be turned off while programming the HomeLink® Universal Transceiver.

Personal lights and Luggage compartment light

Personal lights To turn the rear personal lights on, push the switch. To turn them off, push the switch again. Luggage compartment light The light illuminates when the liftgate is opened...

Programming HomeLink®

If you have any questions or are having difficulty programming your HomeLink® buttons, refer to the HomeLink®website at: www.homelink.com or call 1-800-355-3515...

Other information:

Nissan Murano (Z52) 2015-2024 Owners Manual: Liftgate position setting (if so equipped)

The liftgate can be set to open to a specific height (garage mode) by performing the following: Open the liftgate using the liftgate instrument panel switch, liftgate opener switch or the Intelligent Key button. Pull the liftgate down and move to the desired height position (the liftgate will have some resistance when being manually adjusted)...

Nissan Murano (Z52) 2015-2024 Service Manual: P0794 Intermediate Speed Sensor a

DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0794 INTERMEDIATE SPEED SENSOR A (Intermediate Shaft Speed Sensor "A" Circuit Intermittent) Diagnosis condition TCM power supply voltage: More than 11 V Signal — Threshold Primary pulley speed: more than 11820 rpm Diagnosis delay time Maintained 2 seconds POSSIBLE CAUSE Harness or connector (Primary speed sensor circuit is open or shorted) Primary speed sensor TCM FAIL-SAFE Start is slow Acceleration is slow Lock-up is not performed Manual mode is not activated Confirmation Procedure DTC CONFIRMATION PROCEDURECAUTION: Always drive vehicle at a safe speed...