Description
RELATED TO NOISEThe majority of the audio concerns are the result of outside causes (bad CD, electromagnetic interference, etc.).The following noise results from variations in field strength, such as fading noise and multi-path noise, or external noise from trains and other sources...
Exploded View
1.
Audio unit bracket (RH)
2.
Audio unit
3.
Audio unit bracket (LH)
4.
A/C auto amp.
Removal and Installation
REMOVALCAUTION:
Before disconnecting the audio unit and battery terminals, turn the ignition switch OFF and wait at least 30 seconds...
Other information:
Exploded View
1.
Final drive bracket
2.
Stopper
3.
Rear final drive assembly
Removal and Installation
NOTE:
When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.
Before replacing, servicing, or repairing rear final drive assembly due to vibration and/or noise when making low speed turns, refer to TSB to assist in proper diagnosis...
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C1B52-17
BSW/BSI IND OPEN CIR
(Blind Spot Warning indicator open circuit)
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
–
Threshold
Open circuit in Blind Spot Warning indicator circuit is detected
Diagnosis delay time
–
POSSIBLE CAUSE
Blind Spot Warning indicator RH circuit
Blind Spot Warning indicator RH
Side radar RH
FAIL-SAFEThe following systems are canceled:
Blind Spot Warning (BSW)
Rear Cross Traffic Alert (RCTA)
DTC Confirmation Procedure
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Start the engine...