Nissan Murano: Removal and Installation / Front Door Speaker
Removal and Installation
REMOVAL
Remove front door finisher. Refer to Removal and Installation.
Disconnect the harness connector (A) from front door speaker and remove screws to remove front door speaker (1).

INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation
RemovalRemove A/C switch assembly Removal and Installation.
Disconnect the harness connectors from the front auxiliary input jacks control unit...
Removal and Installation
REMOVALRemove instrument panel tweeter grille (LH\RH). Refer to Exploded View.
Disconnect the harness connector from instrument panel tweeter and remove screws (A) to remove instrument panel tweeter (1)...
Other information:
Diagnosis Procedure
Engine does not start when ignition switch is pressed.SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS) Door lock operation (remote keyless entry) Door lock operation (request switch) or back door open operation (opener switch of back door panel) Engine started with push-button ignition switch operation (registered Intelligent Key is within the detection area of inside key antenna) Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch)
OK
OK
No start
No start
CONDITIONS OF VEHICLE (OPERATING CONDITIONS)“ENGINE START BY I-KEY” setting in “Work support” mode of “BCM(INTELLIGENT KEY)” is ON...
Diagnosis Procedure
Back door auto closure function does not operate when back door opening operations are performed.CHECK BACK DOOR OPENER SWITCH
Check back door opener switch.
Refer to Component Function Check.
Is the inspection result normal?
YES>>
GO TO 2...