Nissan Murano: Standard maintenance / Chassis & body maintenance

Nissan Murano (Z52) 2015-2024 Owners Manual / Maintenance and schedules / Standard maintenance / Chassis & body maintenance

Abbreviations: I = Inspect and correct or replace as necessary, R = Replace,

Nissan Murano. Chassis & body maintenance

NOTE:

Maintenance items with “ ” should be performed more frequently according to “Maintenance under severe driving conditions”.

(1) If towing a trailer, using a camper or a car-top carrier or driving on rough or muddy roads, inspect CVT fluid deterioration every 60,000 miles (96,000 km), then change CVT fluid if necessary.And if the inspection is not performed, change (not just inspect) CVT fluid every 60,000 miles (96,000 km). It is recommended that you visit a NISSAN dealer for this service.

(2) If towing a trailer, using a camper or a car-top, or driving on rough or muddy roads, change (not just inspect) oil at every 20,000 miles (32,000 km) or 24 months.

(3) For additional information on tire rotation, refer to “General maintenance” in this section.

Emission control system maintenance

Abbreviations: I = Inspect and correct or replace as necessary, R = Replace NOTE: (1) After 40,000 miles (64,000 km) or 48 months, inspect every 10,000 miles (16,000 km) or 12 months...

Maintenance under severe operating conditions

The maintenance intervals shown on the preceding pages are for normal operating conditions. If the vehicle is mainly operated under severe driving conditions as shown below, more frequent maintenance must be performed on the following items as shown in the table...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Oil Pump

Removal and Installation REMOVALRemove the engine from the vehicle. Refer to Removal and Installation (FWD) or Removal and Installation (AWD). Remove the upper oil pan. Refer to Removal and Installation (Upper Oil Pan). Remove the timing chain. Refer to Removal and Installation...

Nissan Murano (Z52) 2015-2024 Service Manual: Transfer Cover

Exploded View Oil seal Transfer cover Filler plug Gasket Drain plug Oil seal O-ring Ring gear bearing adjusting shim (transfer cover side) Ring gear bearing (transfer cover side) Drive shaft oil seal Ring gear shaft Ring gear bearing (transfer case side) Ring gear bearing adjusting shim (transfer case side) Ring gear Baffle plate Transfer case Plug O-ring Oil seal Dowel pin Drive pinion Drive pinion adjusting shim O-ring Pinion bearing assembly Oil seal Dust cover Companion flange Pinion lock nut Oil seal lip Comply with the assembly procedure when tightening...