Nissan Murano: Fuses / Passenger compartment

WARNING
Never use a fuse of higher or lower amperage
rating than that specified on the
fuse box cover. This could damage the
electrical system or electronic control
units or cause a fire.
If any electrical equipment does not operate,
check for an open fuse.
NOTE:
The fuse box is located on the driver’s
side of the instrument panel.
- Be sure the ignition switch and the
headlight switch are OFF.
- Pull down on fuse box cover
to remove.
- Locate the fuse that needs to be replaced.
- Remove the fuse with the fuse puller
.

- If the fuse is open
, replace
it with an
equivalent good fuse
.

- Push the fuse box cover to install.
If a new fuse also opens, have the electrical
system checked and repaired. It is recommended
that you visit a NISSAN dealer for
this service.
WARNING
Never use a fuse of higher or lower amperage
rating than that specified on the
fuse box cover. This could damage the
electrical system or electronic control
units or cause a fire...
CAUTION
Be careful not to allow children to swallow
the battery or removed parts.
NISSAN INTELLIGENT KEY®
Replace the battery in the Intelligent Key as
follows:
Remove the mechanical key from the
Intelligent Key...
Other information:
Component Function Check
CHECK REAR WINDOW DEFOGGER SWITCH FUNCTION
Check that the rear window defogger indicator lamp illuminates when the rear window defogger switch is ON.
Is the inspection result normal?
YES>>
Rear window defogger switch function is OK...
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
U111A
REAR CAMERA IMAGE SIGNAL
(CAN COMM CIRCUIT)
Diagnosis condition
When ignition switch is ON
Signal (terminal)
Rear camera image signal (terminal 20)
Threshold
Rear camera image signal circuit is shorted or open
Diagnosis delay time
—
POSSIBLE CAUSE
Rear camera image signal circuit
Around view monitor control unit
Rear camera
FAIL-SAFECamera image is not displayed (gray screen display)
DTC Confirmation Procedure
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON...