Nissan Murano: Removal and Installation / Front Auxiliary Input Jacks Control Unit
Removal and Installation
Removal
Remove A/C switch assembly Removal and Installation.
Disconnect the harness connectors from the front auxiliary input jacks control unit.
Remove the front auxiliary input jacks control unit.
Installation
Installation is in the reverse order of removal.
Exploded View
1.
Steering wheel
2.
Cover
3.
Steering switches
4.
Driver air bag module
A.
Refer to Exploded View.
Pawl
Removal and Installation
REMOVALNOTE:
The steering switches is serviced as an assembly...
Removal and Installation
REMOVALRemove front door finisher. Refer to Removal and Installation.
Disconnect the harness connector (A) from front door speaker and remove screws to remove front door speaker (1)...
Other information:
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC detection condition
C1A27-97
ECD PWR SUPLY CIR
(ECD power supply circuit)
Diagnosis condition
When engine is running
When MAIN switch of ICC system is ON
Signal (terminal)
—
Threshold
ECD system power supply voltage is excessively low
Diagnosis delay time
60 second or more
POSSIBLE CAUSE
ABS actuator and electric unit (control unit) power supply circuit
ABS actuator and electric unit (control unit)
FAIL-SAFEThe following systems are canceled:
Vehicle-to-vehicle distance control mode
Conventional (fixed speed) cruise control mode
Automatic Emergency Braking (AEB) with pedestrian detection
Automatic Emergency Braking (AEB)
Intelligent Forward Collision Warning (I-FCW)
Rear Automatic Braking (RAB)
Confirmation Procedure
CHECK DTC PRIORITY
If DTC “C1A27–97” is displayed with DTC “U1000–01”, “U0415–82” or “U0121–83”, first diagnose the DTC “U1000–01”, “U0415–82” or “U0121–83”...
Exploded View
1.
Tire pressure sensor
2.
Valve cap
3.
Valve core
4.
Valve
A.
Screw
: Parts that are replaced as a set when the tire is replaced.
Removal and Installation
REMOVALRemove the wheel and tire using power tool. Refer to Removal and Installation...
Categories

The gauge indicates the approximate fuel
level in the tank.
The gauge may move slightly during braking,
turning, acceleration, or going up or
down hills.
The gauge needle returns to 0 (Empty) after
the ignition switch is placed in the OFF
position.
read more