Nissan Murano: Ventilation, Heater & Air Conditioner / Heater & Air Conditioning Control System :: Removal and Installation

Nissan Murano (Z52) 2015-2024 Service Manual / Ventilation, Heater & Air Conditioner / Heater & Air Conditioning Control System :: Removal and Installation

Compressor Does Not Operate

Diagnosis Procedure Symptom: A/C compressor does not operate.NOTE: Perform self-diagnoses with CONSULT before performing symptom diagnosis. If DTC is detected, perform the corresponding diagnosis...

A/c Switch Assembly

Removal and Installation REMOVALRemove the cluster lid D. Refer to Removal and Installation. Remove the screws (A) and release pawls. : Pawl Disconnect the harness connector (B) from the A/C switch assembly and remove...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Oil


Description MAINTENANCE OF OIL LEVELThe compressor oil is circulating in the system together with the refrigerant. It is necessary to fill compressor with oil when replacing A/C system parts or when a large amount of refrigerant leaks are detected. It is important to always maintain oil level within the specified level or the following conditions may occur: Insufficient oil amount: Stuck compressor Excessive oil amount: Insufficient cooling (caused by insufficient heat exchange) Oil Type : "Oil"...

Nissan Murano (Z52) 2015-2024 Owners Manual: Exterior and interior lights


* It is recommended that you visit a NISSAN dealer for replacement. Always check with the Parts Department at a NISSAN dealer for the latest parts information. Map light Headlight assembly Personal light Door mirror turn signal light Fog light (if so equipped) High-mounted stop light License plate light Backup (reversing) light assembly Rear combination light Cargo light Daytime running light Replacement procedures All other lights are either type A, B, C or D...

Categories

Fuel gauge

Nissan Murano. Fuel gauge

The gauge indicates the approximate fuel level in the tank.

The gauge may move slightly during braking, turning, acceleration, or going up or down hills.

The gauge needle returns to 0 (Empty) after the ignition switch is placed in the OFF position.

read more

 
Copyright © 2026 www.nimurano.com