Nissan Murano: Power Window Control System :: Symptom Diagnosis / Front Lh Power Window Alone Does Not Operate
Diagnosis Procedure
CHECK FRONT POWER WINDOW MOTOR LH
Check front power window motor LH.
Refer to Component Function Check .
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning parts.
CONFIRM THE OPERATION
Confirm the operation again.
Is the inspection result normal?
YES>>
Check intermittent incident. Refer to Intermittent Incident.
NO>>
GO TO 1.
Diagnosis Procedure
CHECK BCM POWER SUPPLY AND GROUND CIRCUIT
Check BCM power supply and ground circuit.
Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>
GO TO 2...
Other information:
Component Function Check
CHECK FUNCTION
CONSULT
Select “TOUCH SEN RH” in “Data Monitor” mode of “AUTO BACK DOOR”.
Check that the function operates normally according to the following conditions:
Monitor Item Condition Status
TOUCH SEN RH
Touch sensor RH
Other than below
OFF
Detect obstruction
ON
Is the inspection result normal?
YES>>
Touch sensor RH is OK...
DTC Description
DESCRIPTIONECM receives vehicle speed signals from two different paths via CAN communication line: One is from the ABS actuator and electric unit (control unit) via the combination unit and the other is from TCM.DTC DETECTION LOGICAt 20 km/h (13 MPH), ECM detects the following status continuously for 5 seconds or more: The difference between a Nissan Murano vehicle speed calculated by a output speed sensor transmitted from TCM to ECM via CAN communication and the Nissan Murano vehicle speed indicated on the combination meter exceeds 15km/h (10 MPH)...