Nissan Murano: Heater & Air Conditioning Control System :: Removal and Installation / A/c Auto Amp.
| 1. | AV control unit | 2. | AV control unit bracket (LH) | 3. | AV control unit bracket (RH) |
| 4. | A/C auto amp. |
REMOVAL
NOTE:
Before replacing A/C auto amp., perform “Before Replace ECU” of “Read / Write Configuration” to save or print current Nissan Murano vehicle specification. Refer to Description.
Remove the AV control unit. Refer to Removal and Installation AV control unit (navigation with bose) or Removal and Installation AV control unit (navigation without bose).
Remove the screws and one of the AV control unit brackets.
Remove the A/C auto amp.
INSTALLATION
CAUTION:
Be sure to perform “After Replace ECU” of “Read / Write Configuration” or “Manual Configuration” when replacing A/C auto amp. Refer to Description.
Installation is in the reverse order of removal.
A/c Switch Assembly
Removal and Installation
REMOVALRemove the cluster lid D. Refer to Removal and Installation.
Remove the screws (A) and release pawls.
: Pawl
Disconnect the harness connector (B) from the A/C switch assembly and remove...
Ambient Sensor
Removal and Installation
REMOVALRemove the front bumper fascia. Refer to Removal and Installation.
Disconnect the harness connector (A) from the ambient sensor (1)...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Secondary Latch
Removal and Installation REMOVALRemove front grille. Refer to Removal and Installation. Disconnect secondary latch cable from hood lock assembly. Remove bolts and secondary latch.INSTALLATIONInstallation is in the reverse order of removal.CAUTION: Tighten bolts to specified torque...
Nissan Murano (Z52) 2015-2024 Service Manual: P2135 Tp Sensor
DTC Description DTC DETECTION LOGICRationally incorrect voltage is sent to ECM compared with the signals from TP sensor 1 and TP sensor 2. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2135 TP SENSOR-B1 (Throttle/Pedal position sensor/switch “A” / “B” voltage correlation) Diagnosis condition Start engine and let it idle Signal (terminal) TP sensor 1 signal and TP sensor 2 signal Threshold Rationally incorrect voltage is sent to ECM compared with the signals from TP sensor 1 and TP sensor 2 Diagnosis delay time — POSSIBLE CAUSE Harness or connector (TP sensor 1 or 2 circuit is open or shorted...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Power Steering Fluid (PSF)
- GAS STATION INFORMATION
- Indicator lights
- New on site
- Most important about car
Driver and passenger supplemental knee air bag
Driver’s side
The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.
Passenger’s side
