Nissan Murano: Cruise Control System :: Icc / Dtc/circuit Diagnosis

Action Test

Description Always perform the ICC system action test to check that the ICC system operates normally after replacing the distance sensor (ICC sensor) or repairing any ICC system malfunction...

C1a0c Adas Message Counter Failure

DTC Description DTC DETECTION LOGIC DTC No. CONSULT terms DTC detection condition C1A0C (82, 83) ADAS MSG COUNTER Diagnosis condition When ignition switch is ON...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Door Does Not Lock/unlock and Engine Does Not Start (all I-Key/req Sw/push Sw)

Diagnosis Procedure All doors do not lock/unlock using door request switch or back door does not open using back door opener request switch, Intelligent Key, and engine does not start when ignition switch is pressed while carrying Intelligent Key.SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS) Door lock operation (remote keyless entry) Door lock operation (request switch) or back door open operation (opener switch of back door panel) Engine started with ignition switch operation (registered Intelligent Key is within the detection area of inside key antenna) Engine started with ignition switch operation (registered Intelligent Key placed next to ignition switch) NG NG No crank, No start OK CONDITIONS OF VEHICLE (OPERATING CONDITIONS)“ENGINE START BY I-KEY” setting in “Work support” mode of “BCM(INTELLIGENT KEY)” is ON...

Nissan Murano (Z52) 2015-2024 Service Manual: Seat Memory Switch

Component Function Check DATA MONITOR CONSULT Select “MEMORY SW 1”, “MEMORY SW 2” and “SET SW” in “Data Monitor” mode of “AUTO DRIVE POS.”. Check that the function operates normally according to the following conditions: Monitor item Condition Status MEMORY SW 1 Memory switch 1 Push ON Release OFF MEMORY SW 2 Memory switch 2 Push ON Release OFF SET SW Set switch Push ON Release OFF Is the inspection result normal? YES>> Inspection End...