Nissan Murano: Dtc/circuit Diagnosis / Power Supply and Ground Circuit. Distance Sensor (icc Sensor)
CHECK FUSES
Check that the following fuse is not blown:
| Signal name | Fuse No. |
|---|---|
| Ignition power supply | 29 (10A) |
Is the fuse blown?
YES>>Replace the blown fuse after repairing the affected circuit.
NO>>GO TO 2.
CHECK DISTANCE SENSOR (ICC SENSOR) POWER SUPPLY CIRCUIT
Check voltage between Distance sensor (ICC sensor) harness connector and ground.
| Terminal | Condition |
Voltage (Approx.) |
||
| (+) | (–) | |||
| Distance sensor (ICC sensor) | Ground | Ignition switch | ||
| Connector | Terminal | |||
| E219 | 8 | OFF | 0 V | |
| ON | Battery voltage | |||
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair the Distance sensor (ICC sensor) power supply circuit.
CHECK DISTANCE SENSOR (ICC SENSOR) GROUND CIRCUIT
-
Turn the ignition switch OFF.
-
Disconnect the Distance sensor (ICC sensor) unit connector.
-
Check for continuity between Distance sensor (ICC sensor) harness connector and ground.
Distance sensor (ICC sensor) Ground Continuity Connector Terminal E219 1 Yes
Is the inspection result normal?
YES>>Inspection End.
NO>>Repair the Distance sensor (ICC sensor) ground circuit.
U1010 Control Unit(can)
DTC Description
DESCRIPTIONCAN controller controls the communication of ITS communication signal and the error detection.DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition
U1010
CONTROL UNIT (CAN)
[Control unit (CAN)]
Diagnosis condition
When Ignition switch is ON...
Other information:
Nissan Murano (Z52) 2015-2024 Owners Manual: System temporarily unavailable
When radar blockage is detected, the system will be deactivated automatically. The “Unavailable: Side Radar Obstruction” warning message will appear and the BSW/RCTA indicator (white) will blink in the vehicle information display. The systems are not available until the conditions no longer exist...
Nissan Murano (Z52) 2015-2024 Service Manual: Front Lh
Diagnosis Procedure PERFORM INITIALIZATION PROCEDURE Initialization procedure is performed and operation is confirmed. Refer to Work Procedure. Is the inspection result normal? YES>> Inspection End. NO>> GO TO 2. CHECK ENCODER (FRONT LH) CIRCUIT Check encoder (front LH) circuit...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Rear bench seat adjustment
- Warning lights
- Checking engine oil level
- New on site
- Most important about car
Luggage hooks
When securing items using luggage hooks located on the back of the seat or side finisher do not apply a load over more than 6.5 lbs. (29 N) to a single hook.
The luggage hooks that are located on the floor should have loads less than 110 lbs. (490 N) to a single hook.
