Nissan Murano: Dtc/circuit Diagnosis / C1a23 Unit Low Temp
DTC DETECTION LOGIC
| DTC | Trouble diagnosis name | DTC detecting condition |
|---|---|---|
|
C1A23 (97) |
UNIT LOW TEMP | Temperature detected by the temperature sensor integrated in distance sensor (ICC sensor) remains less than -40 °C for 5 seconds or more |
POSSIBLE CAUSE
Temperature around the distance sensor (ICC sensor) becomes extremely low
FAIL-SAFE
The following systems are canceled.
-
Vehicle-to-vehicle distance control mode
-
Automatic Emergency Braking (AEB) with pedestrian
-
Automatic Emergency Braking (AEB)
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Turn the ignition switch OFF.
-
Wait for 10 minutes or more.
-
Start the engine.
-
Turn the ICC MAIN switch of ICC system ON.
-
Perform “All DTC Reading” with CONSULT.
-
Check if the “C1A23-97” is detected as the current malfunction in “Self Diagnostic Result” of “LASER/RADAR”.
Is “C1A23-97” detected as the current malfunction?
YES>>Refer to Diagnosis Procedure..
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
CHECK ENVIRONMENT CONDITION
Check ambient temperature.
Is ambient temperature 0°C (32°F) or more?
YES>>Replace the distance sensor (ICC sensor). Refer to Removal and Installation.
NO>>Perform check again at 0°C (32°F) or more.
C1a21 Unit High Temp
DTC Description
DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition
C1A21–48
UNIT HIGH TEMP
(Unit high temperature)
Diagnosis condition
When Ignition switch is ON...
U1000 Can Comm Circuit
DTC Description
DESCRIPTIONITS COMMUNICATION
ITS communication is a multiplex communication system. This enables the system to transmit and receive large quantities of data at high speeds by connecting control units with two communication lines...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: B242e Hands Free Sensor 2
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detecting condition B242E HANDS FREE SENOR 2 (Kick sensor 2) Diagnosis condition All times Signal (terminal) – Threshold BCM detects the abnormal resistance value of motion activated back door sensor (upper) via serial communication Diagnosis delay time – POSSIBLE CAUSE Motion activated back door sensor (upper) Harness or connectors [motion activated back door sensor (upper) circuit is open or shorted] BCM Motion activated back door control unit FAIL-SAFEInhibit motion activated automatic back door system DTC Confirmation Procedure PERFORM DTC CONFIRMATION PROCEDURE CONSULT Ignition switch ON...
Nissan Murano (Z52) 2015-2024 Service Manual: Front Seat
Exploded View DRIVER SEAT WITH CLIMATE CONTROL 1. Headrest 2. Seat cushion trim 3. Seat cushion pad 4. Seatback assembly 5. Seat cushion outer finisher (RH) 6. Seat belt buckle 7. Seat cushion inner finisher [RH (front)] 8...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Passenger compartment
- High Beam Assist (if so equipped)
- GAS STATION INFORMATION
- New on site
- Most important about car
Front manual seat adjustment (if so equipped)
Your vehicle seats can be adjusted manually. For additional information about adjusting the seats, refer to the steps outlined in this section.
Forward and backward
