Description
Calibration must be performed after removing/replacing the cameras, removing parts (e.g. front grille, door mirror, and others) mounted on the cameras, or replacing the Around view monitor control unit...
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
U0428
ST ANGLE SENSOR CALIBRATION
(Steering angle sensor calibration)
Diagnosis condition
When ignition switch is ON
Signal (terminal)
—
Threshold
—
Diagnosis delay time
—
POSSIBLE CAUSE
Neutral position adjustment of steering angle sensor is not complete
Steering angle sensor
FAIL-SAFE
Predicted course line is not displayed
MOD (Moving Object Detection) function is stopped
DTC Confirmation Procedure
CHECK DTC PRIORITY
If DTC U0428 is displayed with DTC U1232, first perform the diagnosis for DTC U1232...
Other information:
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0863
CONTROL UNIT (CAN)
(TCM Communication Circuit)
Diagnosis condition
Engine is started
Signal
—
Threshold
An error is detected at the initial CAN diagnosis of TCM
Diagnosis delay time
Within 1 second
POSSIBLE CAUSETCMFAIL-SAFE
Selector shock is large
Start is slow
Acceleration is slow
Lock-up is not performed
DTC Confirmation Procedure
PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test...
Shrinking The Sheet Metal
Plastic deformation may cause reduced panel thickness and the panel may stretch. Even when it is repaired using a hammer and dolly, the panel tends to bulge, losing its original shape.In such cases, it must be shrunk to its original shape...