Nissan Murano: Dtc/circuit Diagnosis / Power Supply and Ground Circuit
CHECK FUSE
Check that the following fuses are not blown:
| Terminal No. | Signal name | Fuse No. | Capacity |
|---|---|---|---|
| 40 | Ignition signal | 29 | 10 A |
Are the fuses blown?
YES>>Replace the blown fuse after repairing the affected circuit.
NO>>GO TO 2.
CHECK POWER SUPPLY CIRCUIT
-
Ignition switch OFF.
-
Disconnect around view monitor control unit connector.
-
Check voltage between around view monitor control unit connector and ground.
Around view monitor control unit Ground Condition Voltage
(Approx.)Connector Terminal M96 40 — Ignition switch: ON Battery voltage
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace harness or connectors.
CHECK GROUND CIRCUIT
-
Ignition switch OFF.
-
Check continuity between around view monitor control unit connector and ground.
Around view monitor control unit Ground Continuity Connector Terminal M96 39 — Yes
Is the inspection result normal?
YES>>Inspection End.
NO>>Repair or replace harness or connectors.
U1304 Camera Image Calibration
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
U1304
CAMERA IMAGE CALIB
(Camera image calibration)
Diagnosis condition
When ignition switch is ON
Signal (terminal)
—
Threshold
—
Diagnosis delay time
—
POSSIBLE CAUSECamera calibration is incomplete...
Symptom Diagnosis. Intelligent Around View Monitor System
Symptom Table
INTELLIGENT AROUND VIEW MONITOR SYSTEMNOTE:
Inspect the vehicle for a front license plate frame or cover. If there is a front license plate frame or cover, the front camera will see it and show it on the monitor...
Other information:
Nissan Murano (Z52) 2015-2024 Owners Manual: How to change the set distance to the vehicle ahead
The distance to the vehicle ahead can be selected at any time depending on the traffic conditions. Each time the distance switch is pushed, the set distance will change to long, middle, short and back to long again, in that sequence. Distance Approximate distance at 60 mph (100 km/h) [ft (m)] Long 200 (60) Middle 150 (45) Short 90 (30) The distance to the vehicle ahead will change according to the vehicle speed...
Nissan Murano (Z52) 2015-2024 Service Manual: C1a23 Unit Low Temp
DTC Description DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detecting condition C1A23 (97) UNIT LOW TEMP Temperature detected by the temperature sensor integrated in distance sensor (ICC sensor) remains less than -40 °C for 5 seconds or more POSSIBLE CAUSETemperature around the distance sensor (ICC sensor) becomes extremely lowFAIL-SAFEThe following systems are canceled...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Shift lock release
- Power Steering Fluid (PSF)
- Indicator lights
- New on site
- Most important about car
Luggage hooks
When securing items using luggage hooks located on the back of the seat or side finisher do not apply a load over more than 6.5 lbs. (29 N) to a single hook.
The luggage hooks that are located on the floor should have loads less than 110 lbs. (490 N) to a single hook.
