Nissan Murano: Brake Control System :: Vdc/tcs/abs / Dtc/circuit Diagnosis

Configuration [abs Actuator and Electric Unit (control Unit)]

Work Procedure NOTE: After configuration, ignition switch from OFF to ON and check that the VDC warning lamp turns OFF after staying illuminated for approximately two seconds...

C1101 Wheel Sensor

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen item (Trouble diagnosis content) DTC detected condition C1101 RR RH SENSOR-1 (Rear RH wheel sensor-1) Diagnosis condition When ignition switch ON...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Steering Angle Sensor

Exploded View 1. Spiral cable 2. Steering angle sensor A. Spiral cable screws B. Steering angle sensor screws C. Locating pin Removal and Installation To remove and install the steering angle sensor, remove and install the spiral cable...

Nissan Murano (Z52) 2015-2024 Service Manual: Service Data and Specifications (sds). Service Data and Specifications (sds)

Idle Speed Condition Specification No load* (in P or N position) 625 ± 50 rpm *: Under the following conditions A/C switch: OFF Electric load: OFF (Lights, heater fan & rear window defogger) Steering wheel: Kept in straight-ahead position Ignition Timing Condition Specification No load* (in P or N position) 12 ± 2° BTDC *: Under the following conditions A/C switch: OFF Electric load: OFF (Lights, heater fan & rear window defogger) Steering wheel: Kept in straight-ahead position Calculated Load Value Condition Specification (Using CONSULT or GST) At idle 10 – 35 % At 2,500 rpm 10 – 35 % Mass Air Flow Sensor Supply voltage Approx...