Nissan Murano: Dtc/circuit Diagnosis / C1160 Incomplete Decel G Sensor Calibration

DTC Description

DTC DETECTION LOGIC

POSSIBLE CAUSE

NOTE:

Confirm if DTC is PAST or CRNT. If DTC is CRNT, proceed with Diagnosis Procedure. If DTC is PAST, clear DTC. Do not replace the ABS actuator and electric unit (control unit) for a PAST DTC.

FAIL-SAFE

The following functions are suspended:

• VDC function

• TCS function

• ABS function

• Brake assist function

• Hill start assist function

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 10 seconds before conducting the next test.

GO TO 2.

CHECK DTC DETECTION

CONSULT

1. Ignition switch OFF.

   NOTE:

   Wait at least 10 seconds after ignition switch OFF.

2. Start the engine.

   NOTE:

   Wait at least 10 seconds after start the engine.

3. Select “Self Diagnostic Result” mode of “ABS”.

Is DTC “C1160” detected?

“CRNT” is displayed: Proceed to DTC Diagnosis Procedure.

“PAST” is displayed: Inspection End (Erase the memory of “Self Diagnostic Result” mode of “ABS”.)

To check malfunction symptom before repair: Refer to Intermittent Incident.

Confirmation after repair: Inspection End.

CALIBRATION OF DECEL G SENSOR

Perform calibration of decel G sensor. Refer to Work Procedure.

GO TO 2.

CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)

CONSULT

1. Ignition switch OFF.

   NOTE:

   Wait at least 10 seconds after ignition switch OFF.

2. Start the engine.

   NOTE:

   Wait at least 10 seconds after start the engine.

3. Select “Self Diagnostic Result” mode of “ABS”.

Is DTC “C1160” detected?

Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation.

Inspection End.