Nissan Murano: Dtc/circuit Diagnosis / C1170 Variant Coding

DTC Description

DTC DETECTION LOGIC

POSSIBLE CAUSE

NOTE:

Confirm if DTC is PAST or CRNT. If DTC is CRNT, proceed with Diagnosis Procedure. If DTC is PAST, clear DTC. Do not replace the ABS actuator and electric unit (control unit) for a PAST DTC.

FAIL-SAFE

The following functions are suspended:

• VDC function

• TCS function

• ABS function

• EBD function

• Brake assist function

• Hill start assist function

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 10 seconds before conducting the next test.

GO TO 2.

CHECK DTC DETECTION

CONSULT

1. Ignition switch OFF.

   NOTE:

   Wait at least 10 seconds after ignition switch OFF.

2. Start the engine.

   NOTE:

   Wait at least 10 seconds after start the engine.

3. Perform “Self Diagnostic Result” mode of “ABS”.

Is DTC “C1170” detected?

“CRNT” is displayed: Proceed to DTC Diagnosis Procedure.

“PAST” is displayed: Inspection End (Erase the memory of “Self Diagnostic Result” mode of “ABS”.)

To check malfunction symptom before repair: Refer to Intermittent Incident.

Confirmation after repair: Inspection End.

CONFIGURATION OF ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)

Perform configuration of ABS actuator and electric unit (control unit). Refer to Work Procedure.

CAUTION:

Never replace the ABS actuator and electric unit (control unit).

GO TO 2.

CHECK SELF DIAGNOSTIC RESULT

CONSULT

Replace the ABS actuator and electric unit (control unit) even if other DTC are displayed along with “C1170” in self-diagnosis for “ABS”.

Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation.