Nissan Murano: Exterior Lighting System :: Led Headlamp / Symptom Diagnosis

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Controls / Exterior Lighting System :: Led Headlamp / Symptom Diagnosis

Hazard Switch Circuit

Component Function Check CHECK HAZARD SWITCH SIGNAL CONSULT Ignition switch ON. Select “HAZARD SW” in “Data Monitor” mode of “BCM(FLASHER)”...

Exterior Lighting System Symptoms

Symptom Table NOTE: Perform the “Self Diagnostic Result” with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P0335 Ckp Sensor (pos)


DTC Description DTC DETECTION LOGIC The crankshaft position sensor (POS) signal is not detected by the ECM during the first few seconds of engine cranking. The proper pulse signal from the crankshaft position sensor (POS) is not sent to ECM while the engine is running...

Nissan Murano (Z52) 2015-2024 Service Manual: U0104-82 Adas Can 1


DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0104-82 ADAS CAN CIR1 (ADAS control unit CAN circuit 1) Diagnosis condition When ignition switch is ON. Signal (terminal) – Threshold Side radar detected an error of ITS communication signal that was received from ADAS control unit Diagnosis delay time – POSSIBLE CAUSE ADAS control unit Side radar LH FAIL-SAFEThe following systems are canceled: Blind Spot Warning (BSW) Rear Cross Traffic Alert (RCTA) DTC Confirmation Procedure CHECK DTC PRIORITY If DTC “U0104-82” is displayed with DTC “U1000-01”, first diagnose the DTC “U1000-01”...

Categories

Unfastening the seat belts. Checking seat belt operation

Unfastening the seat belts

Nissan Murano. Unfastening the seat belts. Checking seat belt operation

To unfasten the seat belt, press the button on the buckle Nissan Murano. Unfastening the seat belts. Checking seat belt operation. The seat belt automatically retracts.

read more

 
Copyright © 2026 www.nimurano.com