Nissan Murano: Symptom Diagnosis / Both Side Front Fog Lamps Are Not Turned on
Diagnosis Procedure
Both side front fog lamps are not turned ON in any condition.
COMBINATION SWITCH INSPECTION
Check combination switch. Refer to Symptom Table.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning part.
CHECK FRONT FOG LAMP REQUEST SIGNAL INPUT
CONSULT
-
Select “FR FOG REQ” in “Data Monitor” mode of “IPDM E/R”.
-
While operating the front fog lamp switch, check the monitor status.
| Monitor item | Condition | Monitor status |
| FR FOG REQ |
Front fog lamp switch
(With lighting switch 1ST) |
ON |
On |
| OFF |
Off |
Is the item status normal?
YES>>
Perform the front fog lamp diagnosis. Refer to Diagnosis Procedure.
NO>>
Replace BCM. Refer to Removal and Installation.
Diagnosis Procedure
Both side headlamps (HI) are not turned ON when setting to the lighting switch HI or PASS.COMBINATION SWITCH INSPECTION
Check combination switch...
Other information:
Exploded View
1.
AV control unit bracket (RH)
2.
AV control unit
3.
AV control unit bracket (LH)
4.
A/C auto amp.
Removal and Installation
REMOVALCAUTION:
Before disconnecting the AV control unit and battery terminals, turn the ignition switch OFF and wait at least 30 seconds...
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
U0104-82
ADAS CAN CIR1
(ADAS control unit CAN circuit 1)
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
–
Threshold
Side radar detected an error of ITS communication signal that was received from ADAS control unit
Diagnosis delay time
–
POSSIBLE CAUSE
ADAS control unit
Side radar RH
FAIL-SAFEThe following systems are canceled:
Blind Spot Warning (BSW)
Rear Cross Traffic Alert (RCTA)
DTC Confirmation Procedure
CHECK DTC PRIORITY
If DTC “U0104-82” is displayed with DTC “U1000-01”, first diagnose the DTC “U1000-01”...