Nissan Murano: Symptom Diagnosis / Both Side Headlamps (hi) Are Not Turned on
Diagnosis Procedure
Both side headlamps (HI) are not turned ON when setting to the lighting switch HI or PASS.
COMBINATION SWITCH INSPECTION
Check combination switch. Refer to Symptom Table.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning part.
CHECK HEADLAMP (HI) REQUEST SIGNAL INPUT
CONSULT
-
Select “HL HI REQ” in “Data Monitor” mode of “IPDM E/R”.
-
While operating the lighting switch, check the monitor status.
| Monitor item | Condition | Monitor status |
| HL HI REQ |
Lighting switch
(2ND) |
HI or PASS |
On |
| LO |
Off |
Is the inspection result normal?
YES>>
Replace IPDM E/R. Refer to Removal and Installation.
NO>>
Replace BCM. Refer to Removal and Installation.
Description
LED HEADLAMP
LED brightness and color may slightly change until the temperature becomes stable. This is not a malfunction.
Illumination time lag may occur between right and left...
Diagnosis Procedure
Both side front fog lamps are not turned ON in any condition.COMBINATION SWITCH INSPECTION
Check combination switch. Refer to Symptom Table...
Other information:
Special Service Tool
The actual shape of the tools may differ from those illustrated here.
Tool number
(TechMate No.)
Tool name Description
—
(J-39570)
Chassis Ear
Locating the noise
—
(J-50397)
Squeak and Rattle Kit
Repairing the cause of noise
—
(J-46534)
Trim Tool Set
Removing trim components
Commercial Service Tools
(TechMate No...
The driver and front passenger seat is
equipped with an enhanced seat belt reminder
function. If your vehicle is equipped
with an enhanced seat belt reminder function,
a visual and audible alert will operate if
a driver or front passenger seat belt is unbuckled
at speeds of approximately 9 mph
(15 km/h) or more under the following conditions:
If the driver seat belt is not fastened...