Nissan Murano: Driver Information & Multimedia / Meter, Warning Lamp & Indicator :: Symptom Diagnosis

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Information & Multimedia / Meter, Warning Lamp & Indicator :: Symptom Diagnosis

Steering Switch

Diagnosis Procedure CHECK STEERING SWITCH CIRCUIT Ignition switch OFF. Disconnect combination meter harness connector and spiral cable harness connector...

The Fuel Gauge Indicator Does Not Operate

Diagnosis Procedure Fuel gauge will not indicate from a certain position.PERFORM COMBINATION METER SELF-DIAGNOSIS MODE Perform the self-diagnosis mode of combination meter, and then check that the fuel gauge operates normally...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Meter, Warning Lamp & Indicator :: Basic Inspection. Diagnosis and Repair Work Flow


Work flow OVERALL SEQUENCE Reference 1: On Board Diagnosis Function. Reference 2: DTC Index. Reference 3: Diagnosis Procedure. Reference 4: Component Inspection. Reference 5: Diagnosis Procedure. DETAILED FLOWOBTAIN INFORMATION ABOUT SYMPTOM Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurred...

Nissan Murano (Z52) 2015-2024 Service Manual: Turn Signal Lamp Circuit


Component Function Check CHECK TURN SIGNAL LAMP CONSULT Select "FLASHER" in “Active Test” mode of “BCM(FLASHER)”. While operating the test items, check that the turn signal lamp blinks. LH : Turn signal lamp LH blinking RH : Turn signal lamp RH blinking OFF : The turn signal lamp OFF Is the inspection result normal? YES>> Turn signal lamp circuit is normal...

Categories

LATCH (Lower Anchors and Tethers for CHildren) system

Nissan Murano. LATCH (Lower Anchors and Tethers for CHildren) system

LATCH system lower anchor locations - bench seat

Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.

read more

 
Copyright © 2026 www.nimurano.com