Nissan Murano: Meter, Warning Lamp & Indicator :: Symptom Diagnosis / The Fuel Gauge Indicator Does Not Operate
Fuel gauge will not indicate from a certain position.
PERFORM COMBINATION METER SELF-DIAGNOSIS MODE
Perform the self-diagnosis mode of combination meter, and then check that the fuel gauge operates normally. Refer to On Board Diagnosis Function.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Replace the combination meter. Refer to Removal and Installation.
CHECK COMBINATION METER INPUT SIGNAL
Perform component function check. Refer to Component Function Check.
Does data monitor value match fuel gauge reading?
YES>>GO TO 3.
NO>>Replace combination meter. Refer to Removal and Installation.
CHECK FUEL LEVEL SENSOR UNIT CIRCUITS
Check the fuel level sensor circuits. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 4.
NO>>Repair or replace harness or connector.
CHECK FUEL LEVEL SENSOR UNIT
Check the fuel level sensor unit. Refer to Component Inspection.
Is the inspection result normal?
YES>>GO TO 5.
NO>>Replace fuel level sensor unit. Refer to Removal and Installation.
CHECK FLOAT INTERFERENCE
Check that the float arm does not interfere with or bind to other components in the fuel tank.
Is the inspection result normal?
YES>>Check intermittent incident. Refer to Intermittent Incident.
NO>>Repair or replace malfunctioning parts.
The Meter Control Switch Is Inoperative
Diagnosis Procedure
The meter control switches are inoperative when pressed.CHECK METER CONTROL SWITCH
Check the meter control switch. Refer to Component Inspection...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Intelligent Key System Symptoms
Diagnosis Procedure NOTE: Perform the self diagnosis result with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected. SYMPTOM TABLE 1 (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS) No. Door lock operation (remote keyless entry) Door lock operation (request switch) or back door open operation (opener switch of back door panel) Engine started with ignition switch operation (registered Intelligent Key is within the detection area of inside key antenna) Engine started with ignition switch operation (registered Intelligent Key placed next to ignition switch) Symptom 1 OK OK No start No start Diagnosis Procedure 2 OK NG OK OK Diagnosis Procedure 3 OK NG No crank, No start OK Diagnosis Procedure 4 NG NG No crank, No start OK Diagnosis Procedure 5 NG NG No start No start Diagnosis Procedure 6 OK OK No crank, No start OK Diagnosis Procedure 7 NG OK OK OK Diagnosis Procedure 8 NG NG OK OK Diagnosis Procedure 9 Poor range OK OK OK Diagnosis Procedure SYMPTOM TABLE 2 (ONE INTELLIGENT KEY HAS THE SYMPTOM, OTHER KEYS OPERATE NORMALLY) No...
Nissan Murano (Z52) 2015-2024 Owners Manual: Memory storage function (switch)
Use the following process to manually store the two memory positions in the switch: The vehicle should be stopped while setting the memory. Adjust the driver’s seat, steering columnand outside mirrors to the desired positions by manually operating each adjusting switch...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Power Steering Fluid (PSF)
- GAS STATION INFORMATION
- Jacking up vehicle and removing the damaged tire
- New on site
- Most important about car
Autolight system
The autolight system allows the headlights to turn on and off automatically. The autolight system can:
Turn on the headlights, front parking, tail, license plate and instrument panel lights automatically when it is dark. Turn off all the lights (except daylight running lights) when it is light. Keep all the lights on for a period of time after you place the ignition switch in the OFF position and all doors are closed.