Nissan Murano: Meter, Warning Lamp & Indicator :: Symptom Diagnosis / The Meter Control Switch Is Inoperative
Diagnosis Procedure
The meter control switches are inoperative when pressed.
CHECK METER CONTROL SWITCH
Check the meter control switch. Refer to Component Inspection.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Replace meter control switch. Refer to Removal and Installation.
CHECK METER CONTROL SWITCH SIGNAL
Check the meter control switch signal. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>
Replace combination meter. Refer to Removal and Installation.
NO>>
Repair or replace harness or connector.
Diagnosis Procedure
Fuel gauge will not indicate from a certain position.PERFORM COMBINATION METER SELF-DIAGNOSIS MODE
Perform the self-diagnosis mode of combination meter, and then check that the fuel gauge operates normally...
Diagnosis Procedure
The low oil pressure warning message stays on when oil pressure is normal.
The low oil pressure warning message stays off when oil pressure is low...
Other information:
Exploded View
1.
Spiral cable
2.
Steering angle sensor
A.
Spiral cable screws
B.
Steering angle sensor screws
C.
Locating pin
Removal and Installation
WARNING:
Before servicing the SRS, place the ignition switch in the OFF position, disconnect both battery terminals then wait at least three minutes...
Description
Always perform the RCTA system action test to check that the system operates normally after replacing the side radar LH/RH, or repairing any BSW/RCTA system malfunction.WARNING:
Be careful of traffic conditions and safety around the vehicle when performing road test...