Nissan Murano: Meter, Warning Lamp & Indicator :: Symptom Diagnosis / The Low Washer Fluid Warning Continues Displaying, or Does Not Display

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Information & Multimedia / Meter, Warning Lamp & Indicator :: Symptom Diagnosis / The Low Washer Fluid Warning Continues Displaying, or Does Not Display

Diagnosis Procedure

The warning is still displayed even after washer fluid is added.
The warning is not displayed even though the washer tank is empty.

CHECK WASHER FLUID LEVEL SWITCH SIGNAL CIRCUIT

Check the washer fluid level switch signal circuit. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace harness or connector.

CHECK WASHER FLUID LEVEL SWITCH UNIT

Check the washer fluid level switch. Refer to Component Inspection.

Is the inspection result normal?

YES>>

Replace combination meter. Refer to Removal and Installation.

NO>>

Replace washer fluid level switch. Refer to Removal and Installation.

The Parking Brake Release Warning Continues Displaying, or Does Not Display

Diagnosis Procedure The parking brake warning is displayed during vehicle travel, even though the parking brake is released. The parking brake warning is not displayed, even while driving the Nissan Murano vehicle with the parking brake applied...

The Door Open Warning Continues Displaying, or Does Not Display

Diagnosis Procedure The door open warning is displayed even though all of the doors are closed. The door open warning is not displayed even though a door is ajar...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Power Seat Switch Lh Ground Circuit

Diagnosis Procedure CHECK POWER SEAT SWITCH LH GROUND CIRCUIT Ignition switch OFF. Disconnect power seat switch LH. Check continuity between power seat switch LH connector and ground. Power seat switch LH Ground Continuity Connector Terminal B208 3 Yes Is the inspection result normal? YES>> Check intermittent incident...

Nissan Murano (Z52) 2015-2024 Owners Manual: Engine block heater (if so equipped)

Engine block heaters are used to assist with cold temperature starting. The engine block heater should be used when the outside temperature is 20°F (-7°C) or lower. WARNING Do not use your engine block heater with an ungrounded electrical system or a 2-pronged adapter...