Nissan Murano: Meter, Warning Lamp & Indicator :: Dtc/circuit Diagnosis / Steering Switch

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Information & Multimedia / Meter, Warning Lamp & Indicator :: Dtc/circuit Diagnosis / Steering Switch

Diagnosis Procedure

CHECK STEERING SWITCH CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect combination meter harness connector and spiral cable harness connector.

  3. Check continuity between combination meter harness connector and spiral cable harness connector.

    Combination meter Spiral cable Continuity
    Connector Terminal Connector Terminal
    M24 21 M41 2 Yes
    22 4
    23 3

  4. Check continuity between combination meter harness connector and ground.

    Combination meter — Continuity
    Connector Terminal
    M24 21 Ground No
    22
    23

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Repair or replace harness or connector.

Component Inspection

CHECK STEERING SWITCH RESISTANCE

Check resistance between the following steering switch terminals:

Steering switches Condition

Resistance (Ω)

(Approx.)
Terminals Signal name
32 33 Display Depress switch. 2023
Back Depress switch. 723
31 Enter Depress OK switch. 2023
Menu Up Depress switch. 121
Menu Down Depress switch. 321

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Replace steering wheel switch. Refer to Removal and Installation.

CHECK SPIRAL CABLE

Check continuity between the following spiral cable terminals:

Spiral cable Continuity
Terminals
31 4 Yes
32 3
33 2

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Replace spiral cable. Refer to Removal and Installation.

    Washer Fluid Level Switch Circuit

    Diagnosis Procedure CHECK WASHER FLUID LEVEL SWITCH SIGNAL CIRCUIT Ignition switch OFF. Disconnect combination meter harness connector and washer fluid level switch harness connector...

    Meter, Warning Lamp & Indicator :: Symptom Diagnosis

    ..

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: Repairing Material


    Foam Repair During factory body assembly, foam insulators are installed in certain body panels and locations around the Nissan Murano vehicle. Use the following procedure(s) to replace any factory-installed foam insulators.URETHANE FOAM APPLICATIONSUse commercially available urethane foam for sealant (foam material) repair of material used on vehicle...

    Nissan Murano (Z52) 2015-2024 Service Manual: P0776 Pressure Control Solenoid B


    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0776 PC SOLENOID B (Pressure Control Solenoid “B” Performance/Stuck Off) 1 Diagnosis condition When all of the following conditions are satisfied: DTC other than the applicable DTC is not detected...

    Categories

    read more

     
    Copyright © 2026 www.nimurano.com