Nissan Murano: Meter, Warning Lamp & Indicator :: Symptom Diagnosis / The Oil Pressure Warning Continues Displaying, or Does Not Display
Diagnosis Procedure
CHECK COMBINATION METER INPUT
CONSULT
-
Start the engine.
-
Select “Data Monitor” mode of “METER/M&A”.
-
Select “OIL W/L”.
-
Check that the function operates normally according to the following conditions:
| Monitor item | Condition | CONSULT |
| OIL W/L |
Engine running |
Off |
Is the inspection result normal?
YES>>
Select “Self Diagnostic Result” mode of “ENGINE”. Refer to CONSULT Function.
NO>>
Replace combination meter. Refer to Removal and Installation.
Diagnosis Procedure
The meter control switches are inoperative when pressed.CHECK METER CONTROL SWITCH
Check the meter control switch. Refer to Component Inspection...
Diagnosis Procedure
The parking brake warning is displayed during vehicle travel, even though the parking brake is released.
The parking brake warning is not displayed, even while driving the Nissan Murano vehicle with the parking brake applied...
Other information:
Fill the windshield-washer fluid reservoir periodically.
Add windshield-washer fluid when
the “Low Washer Fluid” warning message
shows on the vehicle information display.
To fill the windshield-washer fluid reservoir,
lift the cap off the reservoir and pour the
windshield-washer fluid into the reservoir
opening...
DTC Description
DTC DETECTION LOGICThe comparison result of signals transmitted to ECM from each temperature sensor (IAT sensor, ECT sensor, FTT sensor, and EOT sensor) shows that the voltage signal of the IAT sensor is higher/lower than that of other temperature sensors when the engine is started with its cold state...