Other information:
Description
For work procedure, refer to Work Procedure.BEFORE REPLACEMENTWhen replacing 3CH CAN gateway, save or print current vehicle specification (Type ID) with CONSULT configuration before replacement.NOTE:
If “Before Replace ECU” of “Read / Write Configuration” can not be used, use the “Manual Configuration” after replacing 3CH CAN gateway...
Exploded View
1.
Spiral cable
2.
Steering angle sensor
A.
Spiral cable screws
B.
Steering angle sensor screws
C.
Locating pin
Removal and Installation
WARNING:
Before servicing the SRS, place the ignition switch in the OFF position, disconnect both battery terminals then wait at least three minutes...