Nissan Murano: Roof :: Removal and Installation / Sunshade
REMOVAL
Open the sunshade with approximately 8 inches showing.
Remove moonroof unit assembly. Refer to Removal and Installation.
Remove panoramic glass. Refer to Removal and Installation.
Release the sunshade by pushing (apply pressure) to driver side of sunshade.
Remove the sunshade by pulling rearward from moonroof tracks.
INSTALLATION
Installation is in the reverse order of removal.
Moonroof Unit Assembly
Inspection
WIND DEFLECTOROpen glass lid fully.
Visually check for proper installation, damaged/deteriorated components, or foreign objects within mechanism...
Sunshade Motor Assembly
Removal and Installation
REMOVALRemove the headlining. Refer to Removal and Installation.
Disconnect the harness connector (A) from the sunshade motor assembly (1)...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Component Parts. Charging System
Component Parts Location A. Engine room left side B. Combination meter No. Component Description 1. Generator (IC regulator) Refer to Generator. 2. Combination meter (charge warning lamp) The IC regulator warning function activates to illuminate the charge warning lamp if any of the following symptoms occur while generator is operating: ·Excessive voltage is produced...
Nissan Murano (Z52) 2015-2024 Service Manual: P014c A/f Sensor 1
DTC Description DTC DETECTION LOGICTo judge malfunctions, this diagnosis measures response time of the A/F signal computed by ECM from the A/F sensor 1 signal. The time is compensated by engine operating (speed and load), fuel feedback control constant, and the A/F sensor 1 temperature index...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- All-Wheel Drive (AWD) (if so equipped)
- GAS STATION INFORMATION
- System malfunction
- New on site
- Most important about car
Autolight system
The autolight system allows the headlights to turn on and off automatically. The autolight system can:
Turn on the headlights, front parking, tail, license plate and instrument panel lights automatically when it is dark. Turn off all the lights (except daylight running lights) when it is light. Keep all the lights on for a period of time after you place the ignition switch in the OFF position and all doors are closed.
Copyright © 2026 www.nimurano.com