Nissan Murano: Roof :: Removal and Installation / Wind Deflector

Nissan Murano (Z52) 2015-2024 Service Manual / Body Exterior, Doors, Roof & Vehicle Security / Roof :: Removal and Installation / Wind Deflector

Removal and Installation

REMOVAL

Open the glass lid to view the wind deflector.

Release upper clips on LH/RH side of the wind deflector.

Release bottom wind deflector clips.

Apply inward pressure on the bottom LH/RH ends of the wind deflector and remove.

INSTALLATION

Installation is in the reverse order of removal.

Sunshade Motor Assembly

Removal and Installation REMOVALRemove the headlining. Refer to Removal and Installation. Disconnect the harness connector (A) from the sunshade motor assembly (1)...

Moonroof Switch

Removal and Installation REMOVALRemove map lamp assembly. Refer to Removal and Installation. Remove center pillar upper finisher. Refer to Removal and Installation...

Other information:

Nissan Murano (Z52) 2015-2024 Owners Manual: Flat towing for front wheel drive vehicle (if so equipped)

Towing your vehicle with all four wheels on the ground is sometimes called flat towing. This method is sometimes used when towing a vehicle behind a recreational vehicle, such as a motor home. CAUTION Failure to follow these guidelines can result in severe transmission damage...

Nissan Murano (Z52) 2015-2024 Service Manual: P0327 Ks

DTC Description DTC DETECTION LOGIC An excessively low voltage from the sensor is sent to ECM. An excessively high voltage from the sensor is sent to ECM. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0327 KNOCK SEN/CIRC-B1 (Knock sensor 1 circuit low bank 1) Diagnosis condition Start engine and let it idle Signal (terminal) Voltage signal transmitted from knock sensor to ECM Threshold An excessively low voltage from the sensor is sent to ECM Diagnosis delay time — P0328 KNOCK SEN/CIRC-B1 (Knock sensor 1 circuit high bank 1) Diagnosis condition Start engine and let it idle Signal (terminal) Voltage signal transmitted from knock sensor to ECM Threshold An excessively high voltage from the sensor is sent to ECM...