Nissan Murano: Roof :: Removal and Installation / Sunshade Motor Assembly

Nissan Murano (Z52) 2015-2024 Service Manual / Body Exterior, Doors, Roof & Vehicle Security / Roof :: Removal and Installation / Sunshade Motor Assembly

Removal and Installation

REMOVAL

Remove the headlining. Refer to Removal and Installation.

Disconnect the harness connector (A) from the sunshade motor assembly (1).

Remove sunshade motor assembly screws (B).

Remove the sunshade motor assembly from the moonroof unit assembly (2).

: Front

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

When replacing moonroof unit assembly, be sure to perform “ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT”. Refer to Special Repair Requirement.

Sunshade

Removal and Installation REMOVALOpen the sunshade with approximately 8 inches showing. Remove moonroof unit assembly. Refer to Removal and Installation...

Wind Deflector

Removal and Installation REMOVALOpen the glass lid to view the wind deflector. Release upper clips on LH/RH side of the wind deflector. Release bottom wind deflector clips...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Automatic Drive Positioner Control Unit

Reference Value TERMINAL LAYOUTPHYSICAL VALUES Terminal No. (wire color) Description Condition Voltage (Approx.) + - Signal name Input/Output 1 (LG) Ground Tilt switch up signal Input Tilt switch Operate (up) 0V Other than above 5V 2 (GR) Ground Select switch RH signal Input Select switch position RH 0V Neutral or LH 5V 3 (G) Ground Mirror switch up signal Input Mirror switch Operated (up) 0V Other than above 5V 4 (P) Ground Mirror switch left signal Input Mirror switch Operated (left) 0V Other than above 5V 5 (W) Ground Door mirror sensor RH up/down signal Input Door mirror RH position Change between 3...

Nissan Murano (Z52) 2015-2024 Service Manual: Preparation. Preparation

Special Service Tool The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description — (J-8092) Driver handle Installing drive shaft oil seal (Use with J-52390) — (J-52390) Transfer case seal installer (1) Installing drive shaft oil seal ST33061000 (J-8107-2) Drift Removing ring gear bearing (left) inner race (transfer case side) a: 38 mm (1...