Nissan Murano: Rear Door / Door Hinge
Removal and Installation
REMOVAL
Remove rear door assembly. Refer to Removal and Installation.
Remove center pillar lower finisher (rear door lower hinge only). Refer to Removal and Installation.
Remove rear door hinge bolts and nuts and rear door hinge.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
-
Tighten nuts/bolts to specification. Refer to Exploded View.
-
Apply anticorrosive agent onto hinge mating surface.
-
After installation, check rear door open/close and lock/unlock operation.
-
After installation, perform rear door adjustment procedure. Refer to Adjustment.
Removal and Installation
REMOVALRemove bolts and rear door striker.INSTALLATIONInstallation is in the reverse order of removal.CAUTION:
Do not reuse rear door striker bolts...
Removal and Installation
REMOVALFully close rear door window.
Remove rear door speaker. Refer to Removal and Installation (DISPLAY AUDIO SYSTEM),Removal and Installation (NAVIGATION WITHOUT BOSE), or Removal and Installation (NAVIGATION WITH BOSE)...
Other information:
To cancel the preset speed, use one of the
following methods:
Push the CANCEL switch. The set vehicle
speed indicator will go out.
Tap the brake pedal. The set vehicle
speed indicator will go out.
If the Cruise Control Alerts are enabled
in the Driver Assistance menu, the
“Cruise ON: Press SET to engage speed
control” message will reappear in the
vehicle information display to let you
know the cruise control system is still
on if you set the target speed again...
Diagnosis Description
AUTO ACTIVE TESTDescriptionIn auto active test mode, the IPDM E/R sends a drive signal to the following systems to check their operation:
Front wiper (LO, HI)
Front fog lamps
Parking lamps
Side marker lamps
Tail lamps
License plate lamps
Headlamps (LO, HI)
A/C compressor
Cooling fans (LO, HI)
Operation ProcedureCAUTION:
Do not start the engine...
Categories

The autolight system allows the headlights
to turn on and off automatically. The autolight
system can:
Turn on the headlights, front parking,
tail, license plate and instrument panel
lights automatically when it is dark.
Turn off all the lights (except daylight
running lights) when it is light.
Keep all the lights on for a period of time
after you place the ignition switch in the
OFF position and all doors are closed.
read more