Nissan Murano: Rear Door / Door Check Link
Removal and Installation
REMOVAL
Fully close rear door window.
Remove rear door speaker. Refer to Removal and Installation (DISPLAY AUDIO SYSTEM),Removal and Installation (NAVIGATION WITHOUT BOSE), or Removal and Installation (NAVIGATION WITH BOSE).
Remove rear door check link bolt (body side).
Remove rear door check link bolts (door side).
Remove rear door check link through hole in rear door panel.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
-
Tighten bolts to specification. Refer to Exploded View.
-
After installation, check rear door open/close and lock/unlock operation.
-
Check rear door check link rotating point for poor lubrication. If necessary, apply a suitable multi-purpose grease.
Removal and Installation
REMOVALRemove rear door assembly. Refer to Removal and Installation.
Remove center pillar lower finisher (rear door lower hinge only)...
Other information:
DTC Description
DTC DETECTION LOGICWhen ECM cannot receive the engine communication signal from active grille shutter. DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
U0284
LOST COMM (A/GRLL SHTTR MDL A)
(Lost communication with active grille air shutter module A)
Diagnosis condition
Ignition switch ON
Signal (terminal)
Engine communication signal
Threshold
ECM cannot receive the engine communication signal from active grille shutter
Diagnosis delay time
—
POSSIBLE CAUSE
Harness and connectors (Engine communication line is open or circuit shorted...
Exploded View
1.
Master cylinder assembly
2.
Vacuum sensor
3.
Brake booster
4.
Lock nut
5.
Clevis
6.
Gasket
Removal and Installation
REMOVALRemove instrument lower panel LH. Refer to Removal and Installation.
Remove harness clip...