Nissan Murano: Maintenance :: Periodic Maintenance / Chassis and Body Maintenance
Nissan Murano (Z52) 2015-2024 Service Manual / Maintenance / Maintenance :: Periodic Maintenance / Chassis and Body Maintenance
- In-Cabin Microfilter
- Exhaust System
- Cvt Fluid
- Transfer Oil
- Rear Differential Gear Oil
- Propeller Shaft
- Wheels
- Brake Fluid Level and Leaks
- Brake Lines and Cables
- Brake Fluid
- Front Brake
- Rear Brake
- Steering Gear and Linkage
- Power Steering Fluid and Lines
- Axle and Suspension Parts
- Drive Shaft
- Seat Belt, Buckles, Retractors, Anchors and Adjusters
Evap Vapor Lines
Work Procedure
CAUTION:
Never use compressed air or a high pressure pump.
Never exceed 4.12 kPa (0.042 kg/cm2, 0.6 psi) of pressure in EVAP system...
In-Cabin Microfilter
Removal and Installation
REMOVALRemove center console side finisher (RH). Refer to Exploded View.
Remove glove box assembly. Refer to Removal and Installation...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: P0520 Eop Sensor
DTC Description DTC DETECTION LOGIC A voltage signal transmitted from the engine oil pressure sensor is lower than 0.26 V. A voltage signal transmitted from the engine oil pressure sensor is higher than 4.9 V. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0520 EOP SENSOR/SWITCH (Engine oil pressure sensor/switch circuit) 1 Diagnosis condition Start engine and let it idle Signal (terminal) Voltage signal transmitted from engine oil pressure sensor to ECM Threshold A voltage signal transmitted from the engine oil pressure sensor is lower than 0...
Nissan Murano (Z52) 2015-2024 Service Manual: Center Ventilator Grille
Removal and Installation REMOVALRemove the cluster lid D. Refer to Removal and Installation. Remove the center ventilator screws. Refer to Exploded View. Release the pawls using a suitable tool and remove the center ventilator grille from the instrument panel...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Tire rotation
- Shift lock release
- Turning the AEB system on/off
- New on site
- Most important about car
LATCH (Lower Anchors and Tethers for CHildren) system
LATCH system lower anchor locations - bench seat
Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.
Copyright © 2026 www.nimurano.com