Nissan Murano: Chassis and Body Maintenance / Rear Brake

Disc Brake Rotor

Inspection INSPECTIONAppearanceCheck surface of disc brake rotor for uneven wear, cracks or damage. Replace if any abnormal conditions exist.RunoutCheck the wheel bearing axial end play before the inspection...

Brake Pad

Inspection INSPECTIONCheck brake pad wear thickness from an inspection hole (A) on cylinder body. Check using a scale if necessary. Wear thickness : Refer to Rear Disc Brake...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: U0300 Can Communication Data

DTC Description DTC DETECTION LOGICWhen the ignition switch is ON, the data length transmitted from each control unit is shorter than the specified length and the status continues for 2 seconds or more. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0300 CAN COMM DATA (Internal Control Module Software Incompatibility) Diagnosis condition When the ignition switch is ON Signal CAN communication data Threshold The data length transmitted from each control unit is shorter than the specified length and the status Diagnosis delay time Continues for 2 seconds or more POSSIBLE CAUSEControl unit other than TCMFAIL-SAFE Selector shock is large Start is slow Acceleration is slow Lock-up is not performed DTC Confirmation Procedure PREPARATION BEFORE WORK If another “DTC CONFIRMATION PROCEDURE” occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test...

Nissan Murano (Z52) 2015-2024 Service Manual: B1328 External Microphone 1

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B1328–13 External Microphone 1 (Microphone) [OPEN] Diagnosis condition When ignition switch is ON. Signal (terminal) — Threshold – Diagnosis delay time 30 seconds or more B1328–11 [GND–SHORT] Diagnosis condition When ignition switch is ON...