Nissan Murano: Chassis and Body Maintenance / Brake Fluid

Drain and Refill

CAUTION:

• Do not spill or splash brake fluid on painted surfaces. Brake fluid may damage paint. If brake fluid is splashed on painted areas, wash it away with water immediately.

• Prior to repair, turn the ignition switch OFF, disconnect the ABS actuator and electric unit (control unit) connector or negative battery terminal. Refer to Removal and Installation.

• Refill brake system with new brake fluid. Refer to Fluids and Lubricants.

• Do not reuse drained brake fluid.

DRAINING

Turn ignition switch OFF and disconnect ABS actuator and electric unit (control unit) connector or negative battery terminal. Refer to Removal and Installation.

Connect a vinyl tube to bleeder valve.

Depress brake pedal, loosen bleeder valve, and gradually remove brake fluid.

CAUTION:

Do not allow master cylinder reservoir tank to empty as this may cause damage to master cylinder internal components.

REFILLING

Make sure no foreign material is in the reservoir sub-tank, and refill with new brake fluid.

CAUTION:

Do not reuse drained brake fluid.

Refill the brake system as follows:

• Depress the brake pedal.

• Loosen bleeder valve.

• Slowly depress brake pedal to 2/3 of the brake pedal full stroke.

• Tighten bleeder valve.

• Release brake pedal.

Repeat this operation at intervals of two or three seconds until all old brake fluid is discharged. Add new brake fluid to master cylinder reservoir sub tank frequently.

CAUTION:

Do not allow master cylinder reservoir to empty as this may cause damage to master cylinder internal components.

Bleed the air out of the brake hydraulic system. Refer to Bleeding Brake System.