Nissan Murano: Chassis and Body Maintenance / Drive Shaft
Check the following items, and replace the parts as necessary.
Check drive shaft mounting points and drive shaft joint for looseness and other damage.
CAUTION:
Replace entire drive shaft when noise or vibration occurs from drive shaft.
Check boot for cracks and other damage.
Axle and Suspension Parts
Inspection
Check front and rear axle and suspension parts for excessive play, cracks, wear or other damage.
Shake each wheel to check for excessive play...
Seat Belt, Buckles, Retractors, Anchors and Adjusters
Inspection
For details, refer to Inspection in SB section.Check anchors for loose mounting.
Check belts for damage.
Check retractor for smooth operation...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Additional Service When Replacing Control Unit
Description Each function is reset to the following condition when the driver seat control unit is replaced. Function Condition Procedure Memory (Seat, steering column, door mirror) Erased Perform storing Entry/exit assist ON Perform initialization Set slide amount*1 Linking a key fob to meter display Erased Perform initialization Perform storing *1: Default value is 40 mm...
Nissan Murano (Z52) 2015-2024 Owners Manual: Continuously Variable Transmission (CVT) fluid
CAUTION NISSAN recommends using Genuine NISSAN CVT Fluid NS-3 (or equivalent) ONLY in NISSAN CVTs. Do not mix with other fluids. Do not use Automatic Transmission Fluid (ATF) or manual transmission fluid in a NISSAN CVT, as it may damage the CVT...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- All-Wheel Drive (AWD) (if so equipped)
- Checking engine oil level
- Vehicle Dynamic Control (VDC) OFF switch
- New on site
- Most important about car
LATCH (Lower Anchors and Tethers for CHildren) system
LATCH system lower anchor locations - bench seat
Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.
