Nissan Murano: Electrical & Power Control / Charging System :: Dtc/circuit Diagnosis

Charging System :: Basic Inspection. Diagnosis and Repair Workflow

Work Flow (With 165-DSS-5000P) CHARGING SYSTEM DIAGNOSIS WITH 165-DSS-5000PTo test the charging system, use the following special service tool: 165-DSS-5000P battery and electrical diagnostic analyzer NOTE: Refer to the applicable instruction manual for proper charging system diagnosis procedures...

Charging System Preliminary Inspection

Diagnosis Procedure CHECK BATTERY TERMINAL CONNECTIONS Check if battery terminals are clean and tight. Is the inspection result normal? YES>> GO TO 2...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Electric Resistance Spot Welding

Principles of Spot Welding Resistance spot welding is a kind of electric resistance welding. It is classified as pressure welding. Two or three sheets of metal are overlapped and pressed, and current is passed through the mating surfaces. As the current flows, the metals melt due to Joule heat at the mating surfaces and are joined by the pressure...

Nissan Murano (Z52) 2015-2024 Service Manual: P2127 App Sensor

DTC Description DTC DETECTION LOGIC An excessively low voltage from the APP sensor 2 is sent to ECM. An excessively high voltage from the APP sensor 2 is sent to ECM. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2127 APP SEN 2/CIRC (Throttle/Pedal position sensor/switch “E” circuit low) Diagnosis condition Start engine and let it idle Signal (terminal) Voltage signal transmitted from APP sensor 2 to ECM Threshold An excessively low voltage is sent to ECM Diagnosis delay time — P2128 APP SEN 2/CIRC (Throttle/Pedal position sensor/switch “E” circuit high) Diagnosis condition Start engine and let it idle Signal (terminal) Voltage signal transmitted from APP sensor 2 to ECM Threshold An excessively high voltage is sent to ECM Diagnosis delay time — POSSIBLE CAUSEDTC P2127 Harness or connectors (APP sensor 2 circuit is open or shorted...