Nissan Murano: Charging System :: Dtc/circuit Diagnosis / L Terminal Circuit (short)

Nissan Murano (Z52) 2015-2024 Service Manual / Electrical & Power Control / Charging System :: Dtc/circuit Diagnosis / L Terminal Circuit (short)

Diagnosis Procedure

CHECK “L” TERMINAL CIRCUIT (SHORT)

Ignition switch OFF.
Disconnect generator connector.
Ignition switch ON.

Does charge warning lamp illuminate?

YES>>

GO TO 2.

NO>>

Refer to Work Flow (With 165-DSS-5000P), or (Without 165-DSS-5000P).

CHECK HARNESS CONTINUITY (SHORT CIRCUIT)

Ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Disconnect combination meter connector.
Check continuity between the combination meter harness connector and ground.

Combination meter — Continuity

Connector Terminal

M23 44 Ground No

Combination meter	—	Continuity
M23	44	Ground	No

Is the inspection result normal?

YES>>

Replace the combination meter. Refer to Removal and Installation.

NO>>

Repair or replace the harness or connectors.

L Terminal Circuit (open)

Diagnosis Procedure CHECK "L" TERMINAL CONNECTION Ignition switch OFF. Check if "L" terminal is clean and tight. Is the inspection result normal? YES>> GO TO 2...

S Terminal Circuit

Diagnosis Procedure CHECK “S” TERMINAL CONNECTION Ignition switch OFF. Check if “S” terminal is clean and tight. Is the inspection result normal? YES>> GO TO 2...

Other information:

Nissan Murano (Z52) 2015-2024 Owners Manual: Rear switch operation

If the rear window wiper operation is interrupted by snow, etc., the wiper may stop moving to protect its motor. If this occurs, turn the wiper switch to OFF and remove the snow, etc. on and around the wiper arms. After about 1 minute, turn the switch ON again to operate the wiper...

Nissan Murano (Z52) 2015-2024 Service Manual: Electronic Controlled Engine Mount

System Description SYSTEM DIAGRAMSYSTEM DESCRIPTIONThe ECM controls the engine mount operation corresponding to the engine speed. The control system has a 2-step control [Soft/Hard] Vehicle condition Engine mount control Engine speed: Below 950 rpm Soft Engine speed: Above 950 rpm Hard ELECTRONIC CONTROLLED ENGINE MOUNT LINE DRAWING Electronic controlled engine mount control solenoid valve Intake manifold collector : From next figure Front electronic controlled engine mount Rear electronic controlled engine mount : To previous figure NOTE: Do not use soapy water or any type of solvent while installing vacuum hose...