Nissan Murano: Driver Information & Multimedia / Warning Chime System :: Symptom Diagnosis

Parking Brake Switch Signal Circuit

Component Function Check COMBINATION METER INPUT SIGNAL CONSULT Select “PKB SW” in “Data Monitor” mode of “METER/M&A”. Check that the function operates normally according to the following conditions: Monitor item Condition Status PKB SW When parking brake is applied ON When parking brake is released OFF Is the inspection result normal? YES>> Inspection End...

Warning Chime System Symptoms

Symptom Table CAUTION: Perform the self-diagnosis with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected. Symptom Possible cause Inspection item The light reminder warning does not sound...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: System Settings Cannot Be Turned On/off

Diagnosis Procedure System setting is not selectable on the combination meter. Intelligent Forward Collision Warning (I-FCW) Intelligent Drive Alertness (I-DA) Traffic Sign Recognition (TSR) Rear Automatic Braking (RAB) Lane Departure Warning (LDW) Blind Spot Warning (BSW) Intelligent Lane Intervention (I-LI) Rear Cross Traffic Alert (RCTA) NOTE: When the ignition switch is in ACC position, each system settings cannot be changed...

Nissan Murano (Z52) 2015-2024 Service Manual: P0603 Ecm

DTC Description DTC DETECTION LOGIC ECM back up system does not function properly. EEPROM (built-in microcomputer) system internal ECM does not function properly. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0603 ECM BACK UP/CIRCUIT [Internal Control Module Keep Alive Memory (KAM) Error] Diagnosis condition Ignition switch ON Signal (terminal) — Threshold ECM back up system does not function properly Diagnosis delay time — P062F CONTROL MODULE (Internal control module EEPROM error) Diagnosis condition Start engine and let it idle Signal (terminal) — Threshold EEPROM (built-in microcomputer) system internal ECM does not function properly Diagnosis delay time — POSSIBLE CAUSEDTC P0603 Harness or connectors [ECM power supply circuit is open or shorted...