Nissan Murano: Warning Chime System :: Symptom Diagnosis / Warning Chime System Symptoms

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Information & Multimedia / Warning Chime System :: Symptom Diagnosis / Warning Chime System Symptoms

Symptom Table

CAUTION:

Perform the self-diagnosis with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected.

Symptom	Possible cause	Inspection item
The light reminder warning does not sound.	Harness between BCM and front door switch LH. Front door switch LH BCM Combination meter	Refer to Diagnosis Procedure.
The parking brake release warning continues sounding or does not sound.	Harness between combination meter and parking brake switch. Parking brake switch BCM Combination meter	Refer to Diagnosis Procedure.
The seat belt warning continues sounding or does not sound.	Harness between combination meter and front seat belt buckle switch LH. Front seat belt buckle switch LH BCM Combination meter	Refer to Diagnosis Procedure.
Warning chime does not sound at all.	Combination meter	Refer to Component Function Check.

Warning Chime System :: Symptom Diagnosis

The Light Reminder Warning Does Not Sound

Diagnosis Procedure Light reminder warning does not sound even though headlamp is illuminated.CHECK COMBINATION SWITCH (LIGHTING SWITCH) OPERATION Check that the headlamps operate normally by operating the combination switch (lighting switch)...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Axle and Suspension Parts

Inspection Check front and rear axle and suspension parts for excessive play, cracks, wear or other damage. Shake each wheel to check for excessive play. Check wheel bearings for smooth operation. Check axle and suspension nuts and bolts for looseness...

Nissan Murano (Z52) 2015-2024 Service Manual: Transaxle Side

Removal and Installation REMOVALRemove drive shaft. Refer to Removal and Installation (LH) (LH) or Removal and Installation (RH) (RH). Secure front drive shaft in a vise. CAUTION: When securing shaft in a vise, always use copper or aluminum plates between vise and shaft...