Nissan Murano: Dtc/circuit Diagnosis / U1a03 Sim Card
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| U1A03 |
SIM CARD (SIM card) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | — | ||
| Threshold | — | ||
| Diagnosis delay time | 1 second or more | ||
POSSIBLE CAUSE
TCU
FAIL-SAFE
-
Telematics system function stops
-
Call the NissanConnect Data Center and inform them that the telematics system cannot be connected.
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON.
-
Erase DTC.
-
Select “Self Diagnostic Result” mode of “TELEMATICS”.
-
Check DTC.
Is DTC U1A03 detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
PERFORM DTC CONFIRMATION PROCEDURE AGAIN
CONSULT
-
Ignition switch ON.
-
Erase DTC.
-
Select “Self Diagnostic Result” mode of “TELEMATICS”.
-
Check DTC.
Is DTC U1A03 detected?
YES>>Replace TCU. Refer to Removal and Installation.
NO>>Inspection End.
U1000 Can Comm Circuit
DTC Description
DESCRIPTIONCAN (Controller Area Network) is a serial communication line for real-time application. It is an on-Nissan Murano vehicle multiplex communication line with high data communication speed and excellent error detection ability...
U1a04 Vin Unfinished
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
U1A04
VIN UNFINISHED
(VIN unfinished)
Diagnosis condition
When ignition switch is ON...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Drive Pinion
Exploded View Stud bolt Connector bracket Reamer bolt Electric controlled coupling assembly Wave spring Drive pinion oil seal Drive pinion lock nut Pinion front bearing Gear carrier Collapsible spacer Drive pinion adjusting shim Pinion rear bearing Drive pinion Drive gear Differential case Side bearing Side bearing adjusting shim Side oil seal Rear cover Stud bolt Gasket Drain plug Filler plug Pinion mate thrust washer Pinion mate gear Side gear thrust washer Side gear Pinion mate shaft Lock pin Oil seal lip Screw hole : N·m (kg-m, in-lb) : N·m (kg-m, ft-lb) : Always replace after every disassembly...
Nissan Murano (Z52) 2015-2024 Service Manual: Optical Sensor Circuit
Component Function Check CHECK OPTICAL SENSOR SIGNAL CONSULT Ignition switch ON. Select “OPTI SEN (DTCT)” in “Data Monitor” mode of “BCM(HEAD LAMP)”. Turn lighting switch AUTO. With the optical sensor illuminating, check the monitor status...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Jacking up vehicle and removing the damaged tire
- Fuel recommendation
- Intelligent Forward Collision Warning (I-FCW)
- New on site
- Most important about car
Autolight system
The autolight system allows the headlights to turn on and off automatically. The autolight system can:
Turn on the headlights, front parking, tail, license plate and instrument panel lights automatically when it is dark. Turn off all the lights (except daylight running lights) when it is light. Keep all the lights on for a period of time after you place the ignition switch in the OFF position and all doors are closed.