Nissan Murano: Wiper & Washer :: Symptom Diagnosis / Normal Operating Condition
FRONT WIPER MOTOR PROTECTION FUNCTION
-
IPDM E/R may stop the front wiper to protect the front wiper motor if any obstruction (operation resistance) such as a large amount of snow is detected during the front wiper operation.
-
At that time turn the front wiper OFF and remove the foreign object. Then wait for approximately 20 seconds or more and reactivate the front wiper. The wiper will operate normally.
REAR WIPER MOTOR PROTECTION FUNCTION
-
BCM may stop the rear wiper to protect the rear wiper motor when the rear wiper is stopped for 5 seconds or more due to a snowfall.
-
The rear wiper operates normally one minute after the obstacles are removed with the rear wiper OFF.
Wiper and Washer System Symptoms
Symptom Table
CAUTION:
Perform the “Self Diagnostic Result” with Consult before performing the diagnosis by symptom. Perform the diagnosis by DTC if DTC is detected...
Front Wiper Does Not Operate
Diagnosis Procedure
The front wiper does not operate under any operation conditions.CHECK WIPER RELAY OPERATION
CONSULT
Select “FRONT WIPER” in “Active Test” mode of “IPDM E/R”...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: P2135 Tp Sensor
DTC Description DTC DETECTION LOGICRationally incorrect voltage is sent to ECM compared with the signals from TP sensor 1 and TP sensor 2. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2135 TP SENSOR-B1 (Throttle/Pedal position sensor/switch “A” / “B” voltage correlation) Diagnosis condition Start engine and let it idle Signal (terminal) TP sensor 1 signal and TP sensor 2 signal Threshold Rationally incorrect voltage is sent to ECM compared with the signals from TP sensor 1 and TP sensor 2 Diagnosis delay time — POSSIBLE CAUSE Harness or connector (TP sensor 1 or 2 circuit is open or shorted...
Nissan Murano (Z52) 2015-2024 Service Manual: Immobilizer Control Module
Removal and Installation RemovalThe immobilizer control module is integrated into the body control module (BCM). For removal and installation, refer to Removal and Installation.Removal (Canada only) Remove instrument panel assembly. Refer to Removal and Installation...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Settings
- Fuel recommendation
- GAS STATION INFORMATION
- New on site
- Most important about car
Autolight system
The autolight system allows the headlights to turn on and off automatically. The autolight system can:
Turn on the headlights, front parking, tail, license plate and instrument panel lights automatically when it is dark. Turn off all the lights (except daylight running lights) when it is light. Keep all the lights on for a period of time after you place the ignition switch in the OFF position and all doors are closed.