Nissan Murano: Parking Brake System :: Removal and Installation / Parking Brake Switch

Nissan Murano (Z52) 2015-2024 Service Manual / Brakes / Parking Brake System :: Removal and Installation / Parking Brake Switch

Removal and Installation

REMOVAL

Remove lower instrument panel LH. Refer to Removal and Installation.

Place fuse box aside.

Disconnect harness connector from parking brake switch.

Remove parking brake pedal assembly nuts and place parking brake pedal assembly aside.

Remove adjusting nut from parking brake pedal.

Remove parking brake switch.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

Replace the parking brake switch if it has been dropped or sustained an impact.

Do not reuse the adjusting nut.

Adjust the parking brake cable if necessary. Refer to Inspection and Adjustment.

Parking Brake Rear Cable

Removal and Installation REMOVALRemove center console assembly. Refer to Removal and Installation. Loosen adjusting nut. Refer to Exploded View. NOTE: It is not necessary to remove parking brake front cable...

Parking Brake Shoe

Exploded View 1. Back plate 2. Parking brake shoe (front) 3. Adjuster 4. Adjuster spring 5. Return spring 6. Anti-rattle spring 7...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Front Door Glass Regulator

Exploded View 1. Front door glass rubber run 2. Front door 3. Front door glass 4. Front door glass rear run 5. Front door power window motor 6. Front door glass regulator Removal and Installation REMOVALRemove front door finisher...

Nissan Murano (Z52) 2015-2024 Service Manual: Back Door Request Switch

Component Function Check CHECK FUNCTION CONSULT Select “REQ SW-BD/TR” in “Data Monitor” mode of “BCM(INTELLIGENT KEY)”. Check that the function operates normally according to the following conditions: Monitor Item Condition Status REQ SW-BD/TR Back door request switch Pressed On Released Off Is the inspection result normal? YES>> Back door request switch is OK...