The cold tire pressure is shown on the Tire
and Loading Information label. The label is
located as shown.
Other information:
Diagnosis Procedure
CHECK FUSE AND FUSIBLE LINK
Check that the following fuse and fusible link are not blown:
Terminal Signal name Fuse or fusible link No. Capacity
25
Battery power supply (brake switch)
10
10A
26
Battery power supply (shorting input)
16
5A
81
Battery power supply (rear wiper)
5
15A
131
Battery power supply
1
10A
138
Battery power supply (rear door)
4
15A
139
Battery power supply
L
40A
142
Battery power supply (front door)
3
15A
Is the fuse or fusible link blown?
YES>>
Replace the blown fuse or fusible link after repairing the affected circuit...
Diagnosis Procedure
Engine does not start when ignition switch is pressed. (One Intelligent Key has the symptom, other keys operate normally.)SYMPTOM TABLE (ONE INTELLIGENT KEY HAS THE SYMPTOM, OTHER KEYS OPERATE NORMALLY) Door lock operation (remote keyless entry) Door lock operation (request switch) or back door open operation (opener switch of back door panel) Engine started with push-button ignition switch operation (Intelligent Key is within the detection area of inside key antenna) Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch)
OK
OK
No crank, No start
No crank, No start
DIAGNOSIS PROCEDURERefer to Diagnosis Procedure...