Nissan Murano: Technical and consumer information / Vehicle identification

When traveling or registering in another country

When planning to drive your NISSAN vehicle in another country, you should first find out if the fuel available is suitable for your vehicle's engine...

Vehicle Identification Number (VIN) plate

The Vehicle Identification Number (VIN) plate is attached as shown. This number is the identification for your vehicle and is used in the vehicle registration...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P0125 Ect Sensor

DTC Description DTC DETECTION LOGIC Voltage sent to ECM from the sensor is not practical, even when some time has passed after starting the engine. Engine coolant temperature is insufficient for closed loop fuel control. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0125 ECT SENSOR (Insufficient coolant temperature for closed loop fuel control) 1 Diagnosis condition — Signal (terminal) Voltage signal transmitted from engine coolant temperature sensor to ECM Threshold Voltage sent to ECM from the sensor is not practical, even when some time has passed after starting the engine Diagnosis delay time — 2 Diagnosis condition — Signal (terminal) Voltage signal transmitted from engine coolant temperature sensor to ECM Threshold Engine coolant temperature is insufficient for closed loop fuel control Diagnosis delay time — POSSIBLE CAUSE Harness and connectors (High resistance in the circuit) Engine coolant temperature sensor Thermostat FAIL-SAFENot applicable DTC Confirmation Procedure CHECK DTC PRIORITY If DTC P00125 is displayed with DTC P0116, P0117 or P0118, first perform the trouble diagnosis for DTC P0116, P0117 or P0118...

Nissan Murano (Z52) 2015-2024 Service Manual: Front Seat Belt Buckle

Removal and Installation REMOVALRemove front seat. Refer to Removal and Installation. Disconnect seat belt buckle harness connector. Remove seat belt buckle anchor bolt and seat belt buckle. CAUTION: Before removing the seat belt buckle anchor bolt, note the positions of washers and spacers for correct installation...