Nissan Murano: Meter, Warning Lamp & Indicator :: Dtc/circuit Diagnosis / Power Supply and Ground Circuit. Combination Meter
CHECK FUSES
Check that the following fuses are not blown:
| Unit | Power source | Fuse No. | Capacity |
|---|---|---|---|
| Combination meter | Battery | 7 | 10 A |
| 13 | 10 A | ||
| Ignition switch ON or ACC | 21 | 10 A | |
| Ignition switch ON or START | 31 | 5 A |
Is the fuse blown?
YES>>Replace the blown fuse after repairing the affected circuit.
NO>>GO TO 2.
CHECK POWER SUPPLY CIRCUIT
-
Disconnect combination meter harness connector.
-
Check voltage between combination meter harness connector and ground.
(+) (–) Ignition switch position Combination meter Connector Terminal OFF ON or ACC START M24 14 Ground 0 V Battery voltage Battery voltage M23 44 0 V Battery voltage Battery voltage 46 Battery voltage Battery voltage Battery voltage
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace harness or connector.
CHECK GROUND CIRCUIT
-
Ignition switch OFF.
-
Check continuity between combination meter harness connector and ground.
Combination meter — Continuity Connector Terminal M24 10 Ground Yes M23 43 45
Is the inspection result normal?
YES>>Inspection End.
NO>>Repair or replace harness or connector.
B2205 Vehicle Speed
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
B2205
Nissan Murano Vehicle SPEED CIRC
[VEHICLE SPEED CIRC]
Diagnosis condition
When ignition switch is ON...
Meter Control Switch Signal Circuit
Diagnosis Procedure
CHECK METER CONTROL SWITCH SIGNAL
Ignition switch ON.
Check voltage between the following terminals of the meter control switch harness connector...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: U1a10 Airbag Signal
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U1A10 AIRBAG SIGNAL (Airbag signal) Diagnosis condition When ignition switch is ON. Signal (terminal) Car crash information signal Threshold Abnormality Diagnosis delay time 1 second or more POSSIBLE CAUSECAN communication systemFAIL-SAFE Some telematics system does not function Inform a NissanConnect center about abnormality DTC Confirmation Procedure PERFORM DTC CONFIRMATION PROCEDURE CONSULT Ignition switch ON...
Nissan Murano (Z52) 2015-2024 Owners Manual: Flat towing for all–wheel drive vehicle (if so equipped)
Towing your vehicle with all four wheels on the ground is sometimes called flat towing. This method is sometimes used when towing a vehicle behind a recreational vehicle, such as a motor home. CAUTION Failure to follow these guidelines can result in severe transmission damage...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- All-Wheel Drive (AWD) (if so equipped)
- Fuel recommendation
- Turning the AEB system on/off
- New on site
- Most important about car
Luggage hooks
When securing items using luggage hooks located on the back of the seat or side finisher do not apply a load over more than 6.5 lbs. (29 N) to a single hook.
The luggage hooks that are located on the floor should have loads less than 110 lbs. (490 N) to a single hook.
