Nissan Murano: Cruise Control System :: Icc / Symptom Diagnosis

Power Supply and Ground Circuit. Distance Sensor (icc Sensor)

Diagnosis Procedure CHECK FUSES Check that the following fuse is not blown: Signal name Fuse No. Ignition power supply 29 (10A) Is the fuse blown? YES>> Replace the blown fuse after repairing the affected circuit...

Intelligent Cruise Control System Symptoms

Symptom Table Symptoms Reference page Operation MAIN switch does not turn ON Diagnosis Procedure MAIN switch does not turn OFF ICC system cannot be set (MAIN switch turns ON/OFF) Diagnosis Procedure CANCEL switch does not function Diagnosis Procedure Resume does not function Set speed does not increase Set distance to a Nissan Murano vehicle ahead cannot be changed ICC is not canceled when the CVT selector lever is in “N” position Diagnosis Procedure Display/Chime ICC system display does not appear System Description Chime does not sound Diagnosis Procedure Control Driving force is hunting Diagnosis Procedure Function to detect a Nissan Murano vehicle ahead System frequently cannot detect a vehicle ahead Diagnosis Procedure Distance to detect a Nissan Murano vehicle ahead is short System misidentifies a vehicle even though there is no vehicle ahead Adjust distance sensor (ICC sensor) alignment: Refer to Work Procedure ...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Brake Pedal Position Switch

Component Function Check CHECK BRAKE PEDAL POSITION SWITCH FUNCTION With CONSULT Turn ignition switch ON. Select “BRAKE SW1” in “DATA MONITOR” mode with CONSULT. Check “BRAKE SW1” indication under the following conditions. Monitor item Condition Indication BRAKE SW1 Brake pedal Slightly depressed OFF Fully released ON Without CONSULT Turn ignition switch ON...

Nissan Murano (Z52) 2015-2024 Service Manual: Partial Replacement of Panel (welded Panel)

Partial Replacement of Panel (Welded Panel) If damage occurs in a welded panel, it can be entirely replaced by a service panel or partial replacement can be done by cutting and replacing damaged portion with a service panel. Welded Panel Replacement Procedure NOTE: When welding and dressing the parts, cover up holes of these parts with tape to prevent debris from entering...