Nissan Murano: RearView Monitor (if so equipped) / How to park with predicted course lines
WARNING
- If the tires are replaced with different
sized tires, the predicted course lines
may be displayed incorrectly.
- On a snow-covered or slippery road,
there may be a difference between
the predicted course line and the actual
course line.
- If the battery is disconnected or becomes
discharged, the predicted
course lines may be displayed incorrectly.
If this occurs, please perform
the following procedures:
- Turn the steering wheel from lock
to lock while the engine is running.
- Drive the vehicle on a straight road
for more than 5 minutes.
- When the steering wheel is turned
with the ignition switch in the ACC position,
the predicted course lines may
be displayed incorrectly.

Visually check that the parking space is
safe before parking your vehicle.
The rear view of the vehicle is displayed
on the screen
when the shift lever
is
moved to the R (Reverse) position.

Slowly back up the vehicle adjusting
the steering wheel so that the predicted
course lines
enter the parking
space
.
Maneuver the steering wheel to make
the vehicle width guide lines
parallel
to the parking space
while
referring
to the predicted course lines.
When the vehicle is parked in the space
completely, move the shift lever to the
P (Park) position and apply the parking
brake.
The displayed guidelines and their locations
on the ground are for approximate
reference only. Objects on uphill or downhill
surfaces or projecting objects will be actually
located at distances different from
those displayed in the monitor relative to
the guidelines (refer to illustrations)...
Press the CAMERA button.
Touch the “Display Settings” key.
Touch the “Brightness,” “Contrast,” “Tint,”
“Color,” or “Black Level” key...
Other information:
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0573
Brake pedal switch A
(Brake Switch "B" Circuit High)
Diagnosis condition
When a deceleration G of -0.13 G or more occurs after the Nissan Murano vehicle speed exceeds 30 km/h (19 MPH)...
Diagnosis Procedure
CHECK INPUT 1 - 5 SYSTEM CIRCUIT FOR OPEN
Ignition switch OFF.
Disconnect BCM connector and combination switch connector.
Check continuity between BCM harness connector and combination switch harness connector.
Combination switch signal
BCM
Combination switch
Continuity
Connector
Terminal
Connector
Terminal
INPUT 1
M19
79
M28
11
Yes
INPUT 2
78
9
INPUT 3
77
7
INPUT 4
76
10
INPUT 5
75
13
Is the inspection result normal?
YES>>
GO TO 2...